Electric current

Current Electricity

Electric current is the rate of flow of electric charge through a conducting medium with respect to time. It is caused by drift of free electrons through a conductor to a particular direction.Charges in motion constitute an electric current. Such currents occur naturally in many situations. Lightning is one such phenomenon in which charges flow from the clouds to the earth through the atmosphere, sometimes with disastrous results. The flow of charges in lightning is not steady, but in our everyday life we see many devices where charges flow in a steady manner. A torch and a cell-driven clock are examples of such devices. Conventionally, the direction of current is taken as the direction in which a positive charge moves. The electrons move in the opposite direction.

The current is the rate of flow of charge through a surface area placed perpendicular to the direction of flow. If charge ?q flows in time ?t, the average current is defined as :

q I av = ———– t

Ohm’s Law:-

A basic law regarding flow of currents was discovered by G.S. Ohm in 1828. Imagine a conductor through which a current I is flowing and let V be the potential difference between the ends of the conductor. Then Ohm‘s law states that :- V? Ior, V = R I

Resistance and Resistivity :-Resistivity ? is an intrinsic property of a material and directly proportional to the total resistance R, an extrinsic quantity that depends on the length and cross-sectional area of a resistor.

The resistivity of a material is found to be dependent on the temperature. Different materials do not exhibit the same dependence on temperatures. Over a limited range of temperatures, that is not too large, the resistivity of a metallic conductor is approximately given by, ?(T) = ?(0) [1 + ? (T– T(0) )]

Series and Parallel circuits Resistance

A series circuit is a circuit in which resistors are arranged in a chain, so the current has only one path to take. The current is the same through each resistor. The total resistance of the circuit is found by simply adding up the resistance values of the individual resistors:

equivalent resistance of resistors in series : R = R1 + R2 + R3 + …

A parallel circuit is a circuit in which the resistors are arranged with their heads connected together, and their tails connected together. The current in a parallel circuit breaks up, with some flowing along each parallel branch and re-combining when the branches meet again. The voltage across each resistor in parallel is the same.

The total resistance of a set of resistors in parallel is found by adding up the reciprocals of the resistance values, and then taking the reciprocal of the total:

equivalent resistance of resistors in parallel: 1 / R = 1 / R1 + 1 / R2 + 1 / R3 +… Krichoff Rules:-

Kirchhoff’s junction rule states that the algebraic sum of the currents at any branch point or junction in a circuit is zero. Symbolically, we may write , below, as the sum of n currents flowing into a junction:

Kirchhoff’s second rule states that the algebraic sum of the potential changes around any complete loop in the network is zero. Again we may write , symbolically ,as the sum of the potential changes:

BPCS Notes brings Prelims and Mains programs for BPCS Prelims and BPCS Mains Exam preparation. Various Programs initiated by BPCS Notes are as follows:- For any doubt, Just leave us a Chat or Fill us a querry––

Leave a Comment